bealy Pull-Out Cabinet Drawers, 2 Pack White Carbon Steel, 16.9 in Deep

Measure the front lip of the cabinet before ordering: anything over half an inch and this will not go in. Below that figure, face-frame and frameless carcasses are both accommodated.

The drawer runs 16.9 inches deep and 9.8 wide with a 3.1 inch side. A handle at the front means you pull it rather than hooking a finger over the edge.

Three sections of damping rail carry the movement, and the drawer travels right out without leaving the runners. Testing to 40,000 openings is quoted.

Fixing uses nano adhesive, one face onto the runner and the other onto the carcass. Nothing is measured for screw holes and nothing is drilled.

Carbon steel in white for rust resistance, and lighter than the expandable pattern, so it stays level as it comes forward under load.

Two drawers per pack, already assembled.

• 16.9 in deep, 9.8 in wide, 3.1 in sides
• Front lip must not exceed 0.5 in
• Suits face-frame and frameless carcasses
• Three-section damping rail, full extension
• Nano adhesive fixing, no drilling
• White carbon steel, two per pack